Pre-press garment for 2-5 seconds, this ensures fibers are flat and no wrinkles are present. Carefully peel off the transfer's backing, ensuring that only the spangle design remains on the clear adhesive sheet. Handle the transfer gently to prevent shifting or misalignment. Before applying, check that the design is intact and free from dust or debris to ensure a smooth and even press.

Place the transfer adhesive side down onto the garment in your desired location, ensuring it is properly aligned. Smooth out any bubbles or wrinkles to create an even application and prevent lifting during pressing. If necessary, use No-Melt Heat Tape to keep the transfer securely in place. Use our Perfect Placement Guide for more precise placement.

Set the heat press to 300-315°F and apply firm pressure for 12-15 seconds. If you're using our Ninja Silicone Garment Protector, set your heat press to 330°F.

Allow the garment to sit for about 5 seconds. Then, carefully peel the carrier sheet while it is still warm, using a smooth and steady motion to prevent lifting. After peeling, inspect the design to ensure all spangles have adhered properly for a flawless finish.